Epoxy Flooring in Atkins, IA

When we quote epoxy flooring in Atkins, the first thing we check is which part of town the house is in. Atkins was founded in 1881 after the Chicago, Milwaukee and St. Paul Railroad came through, and it was named for a railroad official. It stayed small for a long time. Then it grew quickly: 369 housing units in 2000, 610 in 2010 and 747 in 2020. So the town has an older core and a large share of houses built in the last twenty-five years. The garage floors in those two groups need different work.

Older homes near the original town

Garages in the older part of Atkins are often detached, sometimes single-stall, and the slab may have been poured long after the house. These floors commonly have:

• Paint or sealer from earlier projects that has to be ground off
• Pitting near the door from years of salt
• Settled sections or cracks between pours
• Low spots where meltwater pools

We grind down to sound concrete, fill pits and cracks, and level low areas where we can. Then a garage floor coating or epoxy flake system goes on.

Newer homes on the edge of town

Newer Atkins houses usually have attached two- or three-stall garages with smooth, dense slabs. The challenge here is getting a bond. The trowel finish has to be ground open before any primer will grip. Once that is done, these floors take a flake or polyaspartic floor coating very well, and repair work is light.

Get a Free Estimate

A commuter town's garage

Atkins is about 10 miles west of downtown Cedar Rapids, so most households drive into the city for work every day. The 2020 census counted 2,056 people in 719 households. In winter that means two cars bringing in slush and road salt twice a day. A sealed floor lets you push the meltwater out with a squeegee instead of letting it soak into the concrete. A flake finish hides the light salt film that builds up between washes.

Shops and hobby spaces

Some Atkins properties have a detached shop or a deep garage bay used for projects. For floors that see rolling tool chests, floor jacks and spilled oil, we use a shop and commercial floor epoxy system with a thicker build and a chemical-resistant topcoat. If you also want a finished basement, basement floor epoxy or metallic epoxy can go in after a moisture test.

Epoxy or polyaspartic for an Atkins garage?

Both work well here, and many of our floors use both. An epoxy base coat soaks into ground concrete and builds thickness, which helps on older, uneven slabs. A polyaspartic topcoat cures quickly, holds its color in sunlight and resists hot-tire marks. If you need the garage back fast, a full polyaspartic system can shorten the job. If the slab needs a lot of filling and leveling, a thicker epoxy base usually makes more sense. We explain the tradeoff on site, with your floor in front of us, and put the choice in writing.

What you get at the estimate

We measure the floor, test moisture, note every crack and old coating, and explain which system fits. The written quote lists the square footage, the prep, each coat and the total price.